Using remote control HR40/HR43

The HR40 or HR43 remote controls are taken into use in the control panel settings (Manual control panel: Settings or AP/APC control panel: Device settings).

Remote control HR43

The HR43 control knob function is defined by the selected welding process and reflects the adjustment of the control panel's left control knob.

To adjust the welding parameter, turn the knob on the remote control.

In MIG/MAG: With HR43 and X5 AP/APC equipment the adjusted parameter can be selected between wire feed speed and memory channel in the control panel settings.

Remote control HR40

The HR40 control knob functions are defined by the selected welding process and reflect the adjustments of the control panel's two control knobs.

In MIG/MAG: With HR40 and X5 AP/APC equipment the adjusted parameter can be selected between wire feed speed and memory channel in the control panel settings. When the remote mode is set to 'channel', only the left remote control knob is in use.

With HR40/HR43 remote control, the minimum and maximum values affect also the resolution of the remote control adjustment.

For the HR40 remote control, welding equipment firmware version 1.30 or newer is required. Check the currently installed version in the AP/APC control panel's Info view (select 'Device info') or in the Manual control panel's advanced settings (select 'Info'). For more information on firmware updates, contact your local Kemppi dealer.