WeldEye ArcVision

X5 WF APC

This chapter is about the WeldEye ArcVision feature with X5 Wire Feeder 300 APC.

The use of this WeldEye feature requires X5 Wire Feeder 300 APC and a valid Kemppi WeldEye subscription. The X5 equipment includes a link to a free trial registration – featuring also a free trial option for WeldEye ArcVision. For more information on WeldEye, refer to weldeye.com or contact your Kemppi representative.

The WeldEye's ArcVision module (optional) is intended for cloud-based tracking of the welding operations carried out with the welding equipment. The ArcVision on the welding device itself is a connection feature for connecting to the WeldEye cloud service. The actual welding information gathered by the welding equipment is passed on to the WeldEye cloud where it can be accessed using a desktop computer and an internet browser.

To take the WeldEye ArcVision feature in use, the equipment must be connected to the internet via the built-in wireless connection (WLAN). Refer to Wireless connection (WLAN) for instructions.

The X5 FastMig with X5 Wire Feeder 300 APC comes preinstalled with a trial license for ArcVision. The trial license can be activated by following these steps:

1.

On the X5 Wire Feeder 300 APC control panel, go to the WPS view.

2.

Use a QR code reader on your mobile device to open the WeldEye web link or navigate to 'https://register.weldeye.io/weldeye' on your web browser.

3.

Complete the registration process as instructed on the registration page. Once finished, the equipment is connected to WeldEye ArcVision.

You will be required to fill in the serial number and four-digit security pin of your X5 power source. These can be found on the power source rating plate.

The free trial registration includes both the WeldEye Welding Procedures and WeldEye ArcVision modules.