Base settings for 1-MIG and Pulse MIG

For automatic 1-MIG (A) and Pulse MIG () welding, you are required to enter the filler wire and shielding gas information to determine the base welding program.

The Pulse MIG process is available only with Minarc M 223P with 220...240 V supply voltage.

Manual MIG welding doesn't require the filler wire and shielding gas information to be specified.

The filler wire and shielding gas setup can be entered at any time by pressing the material selection button in the control panel.

1.

Select filler wire material by turning and pressing the right control knob.

>>  When the control knob is pressed to confirm the set value, the next settings value is automatically selected for adjustment. The value under adjustment is underlined.

2.

Set filler wire diameter by turning and pressing the right control knob.

3.

Select shielding gas by turning and pressing the right control knob.

4.

Once the filler wire and shielding gas information has been entered, select the welding process by turning and pressing the right control knob. 1-MIG or Pulse MIG:

While most of the available filler wire and shielding gas combinations are supported by both, 1-MIG and Pulse MIG process, some restrictions apply. For more information, refer to Minarc M welding program work packs.

5.

Select a suitable memory channel to save the settings by turning and pressing the right control knob.

On subsequent start-ups, the Minarc M starts with the last used welding process and memory channel.