| 1 |
Power source not calibrated |
Power source calibration has been lost. |
Restart the power source. If problem persists, contact Kemppi service. Note: The equipment operation is limited when this error occurs. |
| 2 |
Too low mains voltage |
Voltage in mains network is too low. |
Restart the power source. If problem persists, contact Kemppi service. |
| 3 |
Too high mains voltage |
Voltage in mains network is too high. |
Restart the power source. If problem persists, contact Kemppi service. |
| 4 |
Power source is overheated |
Too long welding session with high power. |
Do not shut down, let the fans cool the machine. If fans are not running, contact Kemppi service. |
| 17 |
Phase is missing from mains supply |
One or more phases are missing from the mains supply. |
Check the mains cable and its connectors. Check the voltage of mains supply. |
| 34 |
Unknown welding load |
An unknown load connected to DIX connectors. |
Remove any unintended resistive load connected to the welding equipment and restart the power source. |
| 35 |
Too high mains current |
Current drawn from the mains is too high. |
Reduce welding power. |
| 36 |
DC-link undervoltage |
DC-link voltage is too low. |
Check the mains voltage and/or the supply cable. |
| 37 |
DC-link overvoltage |
DC-link voltage is too high. |
Check the mains voltage. |
| 38 |
Mains voltage too high or too low |
Mains voltage is too high or too low. |
Check the mains voltage and/or the supply cable. |
| 40 |
VRD error |
Open circuit voltage exceeds the VRD limit. |
Restart the power source. If problem persists, contact Kemppi service. |
| 81 |
Welding program data missing |
Welding program data has been lost. |
Restart the power source. If problem persists, contact Kemppi service. |
| 244 |
Internal memory failure |
Initialization failed. |
Restart welding system. If problem persists, contact Kemppi service. |
| 250 |
Internal memory failure |
Memory communication failed. |
Restart welding system. If problem persists, contact Kemppi service. |
